STOPPING PROCEDURES FOR STANDBY CONDITION.

TM 32-5895-206-10

At one site, take bearings to two known fixed position

transmitters. Plot those transmitters on an area map or chart.

Plot a straight line through each transmitter location at the

bearing taken to each transmitter. The lines cross at the

approximate location of the receiving set. Figure 2-14 shows an

example of radio compass triangulation.

2-12 STOPPING PROCEDURES FOR STANDBY CONDITION.

Set the recorder/reproducer mode selector switch to OFF. Set

each receiver FUNCTION switch to OFF. Be sure each receiver

LITE switch is in the OFF (center) position.

2-13 STOPPING PROCEDURES FOR SHUTDOWN.

If the set will not be used again soon, remove the batteries from

each unit and store the batteries separately. Store batteries so

that they cannot short circuit against metal objects. Dispose of

any batteries showing leakage, corrosion, or other damage.

Section III. OPERATION UNDER UNUSUAL CONDITIONS

2-14 OPERATION

UNDER

EXTREME

CLIMATIC

CONDITIONS. It may be necessary to operate the radio

receiving set under conditions of extreme cold,

2-67