Location of Repair Parts - TM-11-6625-847-120063

TM 11-6625-847-12

Illustration, Column 8, Section III.

e. Quantity Incorporated in Unit Pack, Column 4,

(1) Figure number, column 8a. Not used.

Section II; Column 5, Section III. Not used.

(2) Item or symbol number, column 8b. The

f. Quantity Incorporated in Unit, Column 6, Section

callout number used to reference the item in the

III. The quantity of repair parts in an assembly is given

illustration appears in this column.

in this column.

D-4.

Location of Repair Parts

g. Maintenance Allowances, Column 3, Section II;

a. When the Federal stock number is unknown,

Column 7, Section III.

follow the procedures given in (1) through (4) below.

(1) The allowance columns are divided into

(1) Locate the appropriate appendix of the

subcolumns. Indicated in each subcolumn opposite each

repair parts list.

item is the total quantity of items authorized for the

(2) If the item or symbol number is available,

number of equipments supported. Items authorized for

locate the item by scrutiny of column 8b of the repair

use as required but not for initial stockage are identified

parts list.

with an asterisk (*) in the allowance column.

(3) If the item, symbol, and figure number are

(2) The

quantitive

allowances

for

not known, check the description column (column 3) in

organizational category of maintenance represents one

the repair parts list to locate the part. The parts in the

initial prescribed load for a 15-day period for the number

column are arranged in alphabetical order.

of equipments supported. Units and organizations

(4) Locate the applicable illustration in this

authorized additional prescribed loads will multiply the

manual and note the figure number and item number.

number of prescribed loads authorized by the quantity of

Use the repair parts listing and locate the item number

repair parts reflected in the appropriate density column

as noted on the illustration.

to obtain the total quantity or repair parts authorized.

b. When the Federal stock number is known, use

(3) Subsequent changes to organizational

the repair part listing to find the repair part and the item

allowances will be limited as follows: No change in the

number.

range of items is authorized. If additional items are

D-5.

Federal Supply Codes

considered necessary, recommendation should be

forwarded to Commanding General, U. S. Army

This paragraph list the Federal supply code and

Electronics Command, ATTN: AMSEL-MR-NMP-CR,

the associated manufacturer's name.

Fort Monmouth, N. J., 07703, for exception or revision

Code

Manufacturer

to the allowance list. Revisions to the range of items

00141 -------Pic Design Corp.

authorized will be made by the USA ECOM National

58189 -------General Dynamics Corp, Electronics

Maintenance Point based upon engineering experience,

Div.

demand data, or TAERS information.

80058 -------Joint Electronics Type Designation

System

80063 -------Army Electronics Command

81349 -------Military Specifications

95712 -------Dage Electric Co., Inc.

96906 -------Military Standards

D-2