CHAPTER 3. ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LISTS (INCLUDING DEPOT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS)

TM 11-5895-867-14&P

CHAPTER 3

ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT

MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LISTS

(INCLUDING DEPOT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS)

Section I. INTRODUCTION

KD - An item of a depot overhaul/repair kit and not

3-1.

Scope

purchased separately.

This part lists spares and repair parts; special tools;

Depot kit defined as a kit that provides items

special test, measurement, and diagnostic equipment

required at the time of overhaul or repair.

(TMDE), and other special support equipment required

MD - Item to be manufactured or fabricated at the depot

for performance of organizational, direct support, and

maintenance level.

general support maintenance of the Technical Control

XB - Item is not procured or stocked. If not available

Facility at Fort Ritchie, Md.

It authorizes the

through salvage, requisition.

requisitioning and issue of spares and repair parts as

XD - A support item that is not stocked. When required,

indicated by the source and maintenance codes.

item will be procured through normal supply channels.

3-2.

General

NOTE

This Repair Parts and Special Tools List is divided into

Cannibalization or salvage may be used

the following sections;

as a source of supply for any items

Section II. Repair Parts List. A list of spares and

source coded above except those coded

repair parts authorized for use in the performance of

XA and aircraft support items as

maintenance. The list also includes parts which must be

restricted by AR 700-42.

removed for replacement of the authorized parts. Parts

lists are composed of functional groups in numeric

(2) Maintenance code.

Maintenance codes are

sequence.

assigned to indicate the levels of maintenance

Section III. Special Tools List. Not applicable.

authorized to USE and REPAIR support items.

Section IV. National Stock Number and Part

The maintenance codes are entered in

Number Index. Not applicable.

the third and fourth positions of the Uniform SMR

3-3.

Explanation of Columns

Code format as follows:

.a. Illustration. This column is divided as follows:

(1) Figure number. Not applicable.

(a) The maintenance code entered in the third

(2) Item number. Not applicable.

position will indicate the lowest maintenance

Source, Maintenance, and Recoverability

level authorized to remove, replace, and use the

(SMR) Codes.

support item. The maintenance code entered in

(1) Source code. Source codes indicate the manner

the third position will indicate one of the following

of acquiring support items for maintenance,

levels of maintenance:

repair, or overhaul of end items. Source codes

are entered in the first and second positions of

Code

Application[ Explanation

the Uniform SMR Code format as follows:

O - Support item is removed, replaced, used at the

organizational level.

Code

Definition

F - Support item is removed, replaced, used at the direct

PA - Item procured and stocked for anticipated or known

support level.

usage.

PD - Support item, excluding support equipment,

procured for initial issue or outfitting and stocked only for

subsequent or additional initial issues or outfitting. Not

subject to automatic replenishment.

3-1