b. Repair parts lists for major components of this
a. This manual lists repair parts required for the
equipment, which do not appear in this technical manual,
performance of direct support and general support
will be found in the following publications:
maintenance of the AN/TPX46(V) 1, 2, 3, 4, and 6.
TM 11-5895-532-34P-2, Interrogator Set AN/TPX-46(V)1, 2, 3, 4, and 6
(Receiver-Transmitter Group OR-85/TPX-46(V))
TM 11-5895-532-34P-3, Interrogator Set AN/TPX-46(V)1, 2, 3, 4, and 6
(Signal Processor CP-926/TPX-46(V))
TM 11-5895-532-34P-4, Interrogator Set AN/TPX-46(V)1, 2, 3, 4, and 6
(Electrical Synchronizer SN-420/TPX-46(V))
TM 11-5895-532-34P-5, Interrogator Set AN/TPX-46(V)1, 2, 3, 4, and 6
(Antenna-Radome AS-2167/TPX-(V); Antenna-Radome AS-2167A/TPX-46(V);
Antenna-Radome AS-2740/TPX-46(V); Control, Antenna C-8738/TPX-46(V);
and Pedestal, Antenna AB-1076/TPX-46(V)).
support items for maintenance, repair, or overhaul of end
items. Source codes are entered in the first and second
This Repair Parts and Special Tools List is divided into
positions of the Uniform SMR Code format as follows:
the following sections:
a. Section II. Repair Parts List. A list of repair
PA - Item procured and stocked for anticipated or
parts authorized for use in the performance of
maintenance. The list also includes parts which must be
PD - Support item, excluding support equipment,
removed for replacement of the authorized parts, Parts
procured for initial issue or outfitting and
lists are composed of functional groups in ascending
stocked only for subsequent or additional
numerical sequence, with the parts in each group listed
initial issues or outfittings. Not subject to
in figure and item number sequence.
b. Section III. Special Tools List. Not applicable.
MD - Item to be manufactured or fabricated at the
c. Section IV. National Stock Number and Part
depot maintenance level.
Number Index. A list, in ascending numerical sequence,
XA - Item is not procured or stocked because the
of all National stock numbers appearing in the listings,
requirements for the item will result in the
followed by a list, in alphanumeric sequence, of all part
replacement of the next higher assembly.
numbers appearing in the listings.
XD - A support item that is not stocked. When
number and part numbers are cross-referenced to each
required, item will be procured through
illustration figure and item number appearance.
normal supply channels.
3. Explanation of Columns
The following provides an explanation of columns found
in the tabular listings:
Cannibalization or salvage may be used as a
a. Illustration. This column is divided as follows:
source of supply for any items source coded
(1) Figure number.
Indicates the figure
above except those coded XA, XD, and
number of the illustration in which the item is shown.
aircraft support items as restricted by AR
(2) Item number. The number used to identify
each item called out in the illustration.
b. Source, Maintenance, and Recoverability Codes
(2) Maintenance code. Maintenance codes are
assigned to indicate the levels of maintenance
(1) Source code. Source codes are assigned
to support items to indicate the manner of acquiring