Section I. INTRODUCTION - TM-11-5895-453-24P0003

TM 11-5895-453-24P

SECTION I

INTRODUCTION

1. Scope

or overhaul of end items. Source codes are en-

tered in the first and second positions of the

This manual lists repair parts; special tools; and

Uniform SMR Code format as follows:

other support equipment required for perform-

ance of organizational, dirsaect support and gen-

Definition

Code

e r a l support maintenance of the AN/TRC-

PA --Item procured and stocked for anticipated

145(V)1, EN/TRC-145(V)2, AN/TRC-145(V)3,

or known usage.

and

AN/TRC-145A(V)2,

AN/TRC-145A(V)1,

PD --Support item, excluding support equip-

AN/TRC-145A(V)3.

ment procured for initial issue or out-

fitting and stocked only for subsequent

2 . General

or additional initial issues or outfit-

These Repair Parts and Special Tools Lists are

t i n g . Not subject to automatic re-

divided into the following sections:

plenishment.

a. Section II. Repair Parts List. A list of re-

XD --A support item that is not stocked. When

pair parts authorized for use in performance of

item

will be procured

required,

maintenance. The list also includes parts which

through normal supply channels.

must be removed for replacement of the au-

NOTE

thorized parts. Parts lists are composed of func-

tional groups in ascending numerical sequence,

Cannibalization or salvage may be

with the parts in each group listed in figure and

used as a source of supply for any items

item number sequence.

source coded above except those coded

b. Section III. Special Tools List. Not applica-

XD, and aircraft support items as re-

ble.

stricted by AR 700-42.

c. Section IV. National Stock Number and

Part Number Index. A list, in ascending Na-

(2) Maintenance code. Maintenance codes

tional item identification number (NIIN last 9

are assigned to indicate the levels of mainte-

nance authorized to USE and REPAIR support

digits) sequence, of all National stock numbers

appearing in the listings, followed by a list, in

items. The maintenance codes are entered in the

alphameric sequence, of all part numbers ap-

third and fourth positions of the Uniform SMR

pearing in the listings. National stock number

Code format as follows:

and part numbers are cross-referenced to each

(a) The maintenance code entered in the

illustration figure and item number appear-

third position will indicate the lowest mainte-

ance.

nance level authorized to remove, replace and

use the support item. The maintenance code en-

3. Explanation of Columns

tered in the third position will indicate one of

The following provides an explanation of col-

the following levels of maintenance:

umns found in the tabular listings:

Application/Explanation

Code

a. Illustration. This column is divided as fol-

O --Support item is removed, replaced, used at

lows:

the organizational level.

(1) Figure number. Indicates the figure

F --Support item is removed, replaced, used at

number of the illustration in which the item is

the direct support level.

shown.

(2) Item number. The number used to iden-

(b) The maintenance code entered in the

tify each item called out in the illustration.

fourth position indicates whether the item is to

b. Source, Maintenance, and Recoverability

be repaired and identifies the lowest mainte-

Codes (SMR).

nance level with the capability to perform com-

plete repair (i.e., all authorized maintenance

(1) Source code. Source codes are assigned

to support items to indicate the manner of ac-

functions). This position will contain one of the

following maintenance codes:

quiring support items for maintenance, repair