|
| TM 11-5895-241-34P
SECTION I
INTRODUCTION
Code
Definition
1. Scope
stocked only for subsequent or additional initial
This manual lists repair parts required for performance of
issues or outfittings. Not subject to automatic
direct support and general support maintenance of the
replenishment.
AN/FSW-8(V).
XA -
Item is not procured or stocked because the
requirements for the item will result in the
2. General
replacement of the next higher assembly.
XD -
A support item that is not stocked. When
This Repair Parts List is divided into the following
required, item will be procured through normal
sections:
supply channels.
a. Section II-Repair Parts List. A list of repair
parts authorized for use in the performance of
NOTE
maintenance. The list also includes parts which must be
removed for replacement of the authorized parts. Parts
Cannibalization or salvage may be used as a
lists are composed of functional groups in ascending
source of supply for any items source coded
numerical sequence, with the parts in each group listed
above, except those coded XA, XD, and
in figure and item number sequence.
aircraft support items as restricted by AR
b. Section III-Special Tools List. Not applicable.
700-42.
c. Section IV--National Stock Number and Part
Number Index. A list, in ascending numerical sequence,
(2) Maintenance code. Maintenance codes are
of all National stock numbers appearing in the listings,
assigned to indicate the levels of maintenance authorized
followed by a list, in alphanumeric sequence, of all part
to USE and REPAIR support items. The maintenance
numbers appearing in the listings.
National stock
codes are entered in the third and fourth positions of the
numbers and part numbers are cross-referenced to each
Uniform SMR Code format as follows:
illustration figure and item number appearance.
(a) The maintenance code entered in the
third position will indicate the lowest maintenance level
3. Explanation of Columns
authorized to remove, replace, and use the support item.
The maintenance code entered in the third position will
The following provides an explanation of columns found
indicate one of the following levels of maintenance:
in the tabular listings:
a. Illustration. This column is divided as follows:
Code
Application/Explanation
(1) Figure number. Indicates the figure
number of the illustration in which the item is shown.
O
-
Support item is removed, replaced, used at the
(2) Item number. The number used to
organizational level.
identify each item called out in the illustration.
F
-
Support item is removed, replaced, used at the
b. Source, Maintenance, and Recoverability
direct support level.
Codes (SMR).
H
-
Support item is removed, replaced, used at the
Source code.
(1)
Source codes are
general support level.
assigned to support items to indicate the manner of
acquiring support items for maintenance, repair, or
(b) The maintenance code entered in the
overhaul of end items. Source codes are entered in the
fourth position indicates whether the item is to be
first and second positions of the Uniform SMR Code
repaired and identifies the lowest maintenance level with
format as follows:
the capability to perform complete repair (i.e., all
authorized maintenance functions). This position will
Code
Definition
contain one of the following maintenance codes:
PA -
Item procured and stocked for anticipated or
Code
Application/Explanation
known usage.
PD -
Support item, excluding support equipment,
F
-The lowest maintenance level capable ofcomplete
procured for initial issue or outfitting and
repair of the support item is the direct support
level.
1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |