Special Information - TM-11-5895-241-20P0003

measure is expressed by a two-character alphabetical

groups, and listings are divided into the same groups.

abbreviation (e.g., ea, in, pr, etc.). When the unit of

(2) Second. Find the illustration covering the

measure differs from the unit of issue, the lowest unit of

functional group or subgroup to which the repair part

issue that will satisfy the required units of measure will

belongs.

be requisitioned.

(3) Third.

Identify the repair part on the

h. Quantity Incorporated in Unit. Indicates the

illustration and note the illustration figure and item

quantity of the item used in the breakout shown on the

number of the repair part.

illustration figure, which is prepared for a functional

(4) Fourth. Using the Repair Parts Listing, find

group, subfunctional group, or an assembly. A "V"'

the figure and item number noted on the illustration.

appearing in this column in lieu of a quantity indicates

b. When Federal Stock Number or Part Number is

that no specific quantity is applicable, (e.g., shims,

Known.

spacers, etc.).

(1) First. Using the Index of Federal Stock

Numbers and Part Numbers, find the pertinent Federal

4. Special Information

stock number or part number. This index is in ascending

FSN sequence, followed by a list of part numbers in

a. The following publication pertains to the AN/FSW-

ascending alphanumeric sequence, cross-referenced to

8(V) and its components: TM 11-5895241-12

the illustration figure number and item number.

Operator's and Organizational Maintenance Manual:

(2) Second. After finding the figure and item

Communications Control Set AN/FSW-8(V).

number, locate the figure and item number in the repair

b. The illustrations in this manual are identical to

parts list.

those published in TM 11-5895241-34P. Only those

parts assigned the third position SMR maintenance code

6. Abbreviations Not applicable.

"C" or "O" are listed in the tabular listing, therefore, there

may be a break in the item number sequence. Only

illustrations containing organizational authorized items

7. Recommendation for Equipment Publications

appear in this manual.

Improvement The reporting of errors, omissions, and

recommendations for improving this publication by the

5. How to Locate Repair Parts

individual user is encouraged.

Reports should be

submitted on DA Form 2028 (Recommended Changes

a. When Federal Stock Number or Part Number is

to Publications and Blank Forms) and forwarded direct to

Unknown:

Commander, US Army Electronics Command, ATTN:

(1) First. Using the table of contents, determine the

AMSEL-MA-Q, Fort Monmouth, NJ 07703.

functional group or subgroup within which the repair part

belongs.

This is necessary since illustrations are

prepared

for

functional

groups

sub

(Next printed page is 5.)