Table 3-2. Troubleshooting Procedures - TM-11-5895-1195-100072

High RF power is present at the antenna tip when transmitting. Do not

key the transmitter when personnel are closer than 4 inches in the low

power mode, or 16 inches in the high power (20 W) mode. To do so may

result in personnel injury.

CAUTION

Make sure the power supply power cable is disconnected and the R/T PWR switch

is turned off before you replace the RIT unit, battery supply, fuses, or the charging

cable. Failure to do so may result in equipment damage.

Table 3-2. Troubleshooting Procedures

MALFUNCTION

Test or Inspection

Corrective Action

1. PWR indicator fails to light

Step 1 Turn off PWR switch and check front panel fuse.

If blown, replace fuse. If not, install known-good

batteries.

3-5