Scanning Operation

XMT PWR (21)

HIGH

SPKR/MODE (4)

PT ON (for speaker)

PT OFF (for handset)

VOL (19)

Fully CCW

SQ (6)

Fully CCW

g. Set Radio PWR (15) and COMSEC equipment to ON.

h. Turn Radio VOL control (19) CW until noise is heard in speaker (or handset).

Slowly turn Radio SO control (6) CW until noise is just turned off.

Set SPKR/MODE switch (4) to CT.

k. Transfer handset to COMSEC equipment handset connector.

Refer to COMSEC equipment operator's manual for further instructions.

12-13. Scanning Operation

The scanning operation is used when one main channel and two guard channels or either of the guard channels are to be

monitored. The scan mode can be used in any configuration, but will scan only when the function selector is in positions

1 through 6. To operate in the scan mode, refer to Figure 2-7 and perform the following procedures:

2-37