|
| constantly monitor the frequencies set into the front panel rotary select switches which are programmed into the receiver
by the FREQ SELECTION lines. When a transmission is detected on one of the preset frequencies, the scan stops. The
receiver then monitors the detected frequency and passes the received signal through the RCV AUDIO line to the
speaker or handset earphone. After the message is finished, the receiver again scans the selected frequencies for
another incoming message.
1-21. Beacon Mode
This is an automatic mode in which the radio transmits a continuous signal tone on a frequency that is set by the
operator. The operator cannot transmit or receive voice messages while in the beacon mode of operation. In this mode,
the front panel BEACON switch is turned on, enabling the transmitter circuits through the XMT AUDIO line. The
frequency of transmission is programmed into the transmitter by the signal on the FREQ SELECTION line. Placing the
radio in the beacon mode automatically turns the transmit/receive switch to transmit so that the beacon tone passes to
the UHF/VHF switch. Selection of a UHF or VHF beacon frequency automatically switches the UHF/VHF switch so that
the signal is routed to and transmitted by the proper antenna.
1-21
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |