|
| TM 11-5830-263-20&P
B-3 EXPLANATION OF COLUMNS IN THE MAC, SECTION II (continued)
(4) Maintenance Category. Column 4 specifies, by the listing of a work time figure in the
appropriate sub-column(s), the category of maintenance authorized to perform the function listed in
column 3. This figure represents the active time required to perform that maintenance function at
the indicated category of maintenance. If the number or complexity of the tasks within the listed
maintenance function vary at different maintenance categories, appropriate work time figures will be
shown for each category. The work time figure represents the average time required to restore an
item (assembly, subassembly component, module, end item, or system) to a serviceable condition
under typical field operating conditions. This time includes preparation time (including any
necessary disassembly/assembly time), troubleshooting/fault location time, and quality
assurance/quality control time in addition to the time required to perform specific tasks identified by
the maintenance functions authorized in the maintenance allocation chart. The symbol designations
for the various maintenance levels are as follows:
C
Operator or Crew
O
Organizational Maintenance
F
Intermediate Direct Support Maintenance
H
Intermediate General Support Maintenance
D
Depot Maintenance
(5) Tools and Equipment. Column 5 specifies, by code, those common tool sets (not individual
tools) and special tools, TMDE, and support equipment required to perform the designated function.
(6) Remarks. This column shall, when applicable, contain a letter code, in alphabetic order, which
shall be keyed to the remarks contained in Section IV.
B-4 EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT REQUIREMENTS,
SECTION III
A. Column 1, Reference code. The tool and test equipment reference code correlates with a code
used in the MAC, Section II, Column 5.
B. Column 2, Maintenance Category. The lowest level of maintenance authorized to use the tool
or test equipment.
C. Column 3, Nomenclature. Name or identification of the tool or test equipment.
D. Column 4, National/NATO Stock Number. The National Stock Number of the tool or TMDE.
E. Column 5, Tool Number. The manufacturer's part number.
B-5 EXPLANATION OF COLUMNS IN REMARKS, SECTION IV
A. Reference Code. The code recorded in column 6, Section II.
B. Remarks. This column lists information pertinent to the maintenance function being performed
as indicated in the MAC, Section II.
B-3
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |