Tool and Test Equipment Requirements

TM 11-5825-270-23

individual tools) and special tools, test and support

column 3.

This figure represents the active time

equipment required to perform the designated function.

required to perform that maintenance function at the

f. Column 6 Remarks. Column 6 contains an

indicated category of maintenance. If the number or

alphabetic code which lads to the remark in section IV,

complexity of the tasks within the listed maintenance

Remarks, which is pertinent to the item opposite the

function vary at different maintenance categories,

particular code.

appropriate "work time" figures will be shown for each

category. The number of task-hours specified by the

B-4. Tool and Test Equipment Requirements

"work time" figure represents the average time required

(Sect. III)

to restore an item (assembly, subassembly, component,

module, end item or system) to a serviceable condition

a. Tool or Test Equipment Reference Code. The

under typical field operating conditions. This time

numbers in this column coincide with the numbers used

includes preparation time, troubleshooting time, and

in the tools and equipment column of the MAC. The

quality assurance/quality control time in addition to the

numbers indicate the applicable tool or test equipment

time required to perform the specific task identified for

for the maintenance functions.

the maintenance functions authorized in the

b. Maintenance Category.

The codes in this

maintenance allocation chart. Subcolumns of column 4

column indicate the maintenance category allocated the

are as follows:

tool or test equipment.

c. Nomenclature. This column lists the noun name

C - Operator/Crew

and nomenclature of the tools and test equipment

O - Organizational

required to perform the maintenance functions.

F - Direct Support

d. National/NATO stock Number This column lists

H - General Support

the National/NATO stock number of the specific tool or

L - Specialized Repair Activity

test equipment.

D - Depot

e. Tool Number.

This column lists the

NOTE

manufacturer's part number of the tool followed by the

If the SRA in your geographical area

Federal Supply Code for manufacturers (5-digit) in

does not have the capability for the

parentheses.

"L" maintenance functions listed in

B-5. Remarks (Sect. IV)

the MAC, or if there is no SRA in your

geographical area, utilize existing

a. Reference Code.

This code refers to the

procedures for obtaining depot

accomplishment

the

"L"

appropriate item in section II, column 6.

b. Remarks. This column provides the required

maintenance functions.

explanatory information necessary to clarify items

e. Column 5 Tools and Equipment. Column 5

appearing in section II.

specifies by code, those common tool sets (not

(Next printed page is B-3)

B-2