Section I. INTRODUCTION - TM-11-5825-202-34P0003

TM 11-5825-202-34P

SECTION I

INTRODUCTION

Code

Explanation

1-1. Scope This manual lists repair parts and special

tools required for the performance of direct support,

initial issues or out fittings. Not subject to

general support, and depot maintenance of the AN/GRN-

automatic replenishment.

6. The PCCN for the AN/GRN-6 is GANABE for all

PE-

Support equipment procured and stocked for

models.

initial issue or outfitting to specified maintenance

repair activities.

1-2. General

PF-

Support equipment which will not be stocked but

This repair parts and special tools list is divided into the

which will be centrally procured on demand.

following sections:

PG-

Item procured and stocked to provide for

a. Repair Parts List-Section II. A list of re- pair

sustained support for the life of the equipment. It

parts authorized for the performance of maintenance at

is applied to an item peculiar to the equipment

the direct support, general support, and depot level. This

which because of probable discontinuance or

repair parts list is arranged in alphabetical order.

shutdown of production facilities would prove

b. Special Tools, Test and Support Equipment -

uneconomical to reproduce at a later time.

Section III. Not applicable.

KD-

An item of depot overhaul/repair kit and not

c. Index-Federal Stock Number and Reference

purchased separately. Depot kit de- fined as a

Number Cross-Reference to Figure and Item Number-

kit that provides items required at the time of

Section IV. A list, in ascending numerical sequence, of

overhaul or repair.

all Federal stock numbers appearing in the listings,

KF-

An item of a maintenance kit and not purchased

followed by a list, in alphameric sequence, of all

separately. Maintenance kit defined as a kit that

reference numbers appearing in the listings. Federal

provides an item that can be replaced at

stock number and reference numbers are cross-

organizational or direct sup- port or general

referenced to each illustration figure and item number or

support levels of maintenance.

reference designation appearance.

KB-

Item included in both a depot overhaul/re- pair kit

and a maintenance kit.

1-3. Explanation of Columns

MO-

Item to be manufactured or fabricated at

The following provides an explanation of columns found

organizational level.

in the tabular list.

MF-

Item to be manufactured or fabricated at direct

a. Source, Maintenance, and Recoverability

support maintenance level.

Codes (SMR).

MH-

Item to be manufactured or fabricated at general

(1) Source code. Indicates the manner of acquiring

support maintenance level.

support items for maintenance, repair, or overhaul of end

MD-

Item to be manufactured or fabricated at depot

items. Source codes are-

maintenance level.

Code

Explanation

AO-

Item to be assembled at organizational level.

PA-

Item procured and stocked for anticipated or

AF-

Item to be assembled at direct support

known usage.

maintenance level.

PB-

Item procured and stocked for insurance

AH-

Item to be assembled at general support

purposes because essentiality dictates that a

maintenance level.

minimum quantity be available in the supply,

AD-

Item to be assembled at depot maintenance

systems.

level.

PC-

Item procured and stocked and which otherwise

XA-

Item is not procured or stocked because the

would be coded PA except that it is deteriorative

requirements for the item will result in the

in nature

replacement of the next higher assembly.

PD-

Support item, excluding support equipment,

procured for initial issue or outfitting and stocked

only for subsequent or additional