Section I. INTRODUCTION - TM-11-5825-202-20P0002

*TM 11-5825-202-20P

SECTION I

INTRODUCTION

Code

Explanation

1-1. Scope

PE - Support equipment procured and stocked for initial

This manual lists repair parts and special tools required

issue or outfitting to specified maintenance

for the performance of organizational maintenance of the

repair activities.

AN/GRN-6. The PCCN for the AN/GRN-6 is GANABE for

PF - Support equipment which will not be stocked but

all models.

which will be centrally procured on demand.

1-2. General

PG - Item procured and stocked to provide for sustained

This repair parts and special tools list is divided into the

support for the life of the equipment. It is applied

following sections:

to an item peculiar to the equipment which

a. Prescribed Load Allowance(PLA)--Section II. Not

because of probable discontinuance or

applicable.

shutdown of production facilities would prove

b. Repair Parts List--Section III. A list of repair parts

uneconomical to reproduce at a later time.

authorized for the performance of maintenance at the

KD - An item of depot overhaul/repair kit and not

organizational level. This repair parts list is arranged in

purchased separately. Depot kit defined as a kit

alphabetical order.

that provides items required at the time of

c. Special Tools, Test and Support Equipment-

overhaul or repair.

Section IV. Not applicable.

KF - An item of a maintenance kit and not purchased

d. Index--Federal Stock Number and Reference

separately. Maintenance kit defined as a kit that

Number Cross-Reference to Figure and Item Number-

provides an item that can be replaced at

Section V.. A list, in ascending numerical sequence, of

organizational or direct support or general

all Federal stock numbers appearing in the listings,

support levels of maintenance.

followed by a list, in alphameric sequence, of all

KB - Item included in both a depot overhaul/repair kit and

reference numbers appearing in the listings. Federal

a maintenance kit.

stock number and reference numbers are cross-

MO - Item to be manufactured or fabricated at organiza-

referenced to each illustration figure and item number or

tional level.

reference designation appearance.

MF - Item to be manufactured or fabricated at direct

1-3. Explanation of Columns

support maintenance level.

The following provides an explanation of columns

MH - Item to be manufactured or fabricated at general

in the tabular lists-

support maintenance level.

a. Source, Maintenance, and Recoverability Codes

MD - Item to be manufactured or fabricated at depot

(SMR).

maintenance level.

(1) Source code. Indicates the manner of

AO - Item to be assembled at organizational level.

acquiring support items for maintenance, repair, or

AF - Item to be assembled at direct support main-

overhaul of end items. Source codes are-

tenance level.

AH - Item to be assembled at general support main-

Code

Explanation

tenance level.

PA - Item procured and stocked for anticipate or known

AD - Item to be assembled at depot maintenance level.

usage.

XA - Item is not procured or stocked because the re-

PB - Item procured and stocked for insurance purposes

quirements for the item will result in the

because essentiality dictates that a minimum

replacement of the next higher assembly.

quantity be available in the supply systems.

XB - Item is not procured or stocked. If not available

PC - Item procured and stocked and which otherwise

through salvage, requisition.

would be coded PA except that it is deteriorative

XC - Installation drawing, diagram instruction sheet, field

in nature.

service drawing, that is identified by

PD - Support item, excluding support equipment,

manufacturers' part number.

procured for initial issue or outfitting and stocked

XD - Support items can be requisitioned with justifica-

only for subsequent or additional initial issues or

tion.

outfittings.

Not

subject

automatic

replenishment.