|
| |
TM 11-5821-333-12
6-23. REPAIR OF C-11466 OR C-11466A RADIO SET CONTROL.
This task covers: a. Removal
b. Repair (knobs only)
c. Installation
INITIAL SETUP
Tools
Tool Kit, Electronic Equipment, TK-101/G
General Safety Precaution
WARNING
An ungrounded helicopter may store a static electric charge. Ground helicopter electrically and
turn power off before performing any maintenance. Serious burns or electrical shock can result
from contact with exposed wires or connectors.
REMOVAL
a. Loosen four fasteners (1).
b. Pull control unit out far enough to reach its back.
c. Disconnect cable from radio set control.
d. Lift control unit out of panel.
REPAIR
a. Loosen two set screws.
b. Lift knob (2) from shaft.
c. Replace as required.
d. Install knob (2) on shaft.
e. Tighten set screws.
INSTALLATION
a.
b.
c.
Position radio set control in panel to reach
mating cable.
Connect cable to back of radio set control.
Tighten four fasteners (1).
6-48
|
