Tool and Test Equipment Requirements - TM-11-5821-285-12-10063

TM 11-5821-285-12-1

f Column 6, Remarks. Column 6 contains an

the group numbers in the MAC and RPSTL coincide.

d. Column 4, Maintenance Category. Column 4

alphabetic code which leads to the remark in section IV,

specifies, by the listing of a "work time" figure in the

Remarks, which is pertinent to the item opposite the

appropriate subcolumn(s), the lowest level of

particular code.

maintenance authorized to perform the function listed in

column 3. This figure represents the active time required

C-4. Tool and Test Equipment Requirements

to perform that maintenance function at the indicated

(Sect. III)

category of maintenance. If the number or complexity of

a Tool or Test Equipment Reference Code. The

the tasks within the listed maintenance function vary at

numbers in this column coincide with the numbers used

different maintenance categories, appropriate "work

in the tools and equipment column of the MAC. The

time" figures will be shown for each category. The

numbers indicate the applicable tool or test equipment

number of task-hours specified by the "work time" figure

for the maintenance functions.

represents the average time required to restore an item

b. Maintenance Category. The codes in this column

(assembly, subassembly, component, module, end item

indicate the maintenance category allocated the tool or

or system) to a serviceable condition under typical field

test equipment.

operating conditions. This time includes preparation

c. Nomenclature. This column lists the noun name

time, troubleshooting time, and quality assurance/quality

and nomenclature of the tools and test equipment

control time in addition to the time required to perform

required to perform the maintenance functions.

the specific tasks identified for the maintenance

d. National/NATO Stock Number. This column lists

functions authorized in the maintenance allocation chart.

the National/NATO stock number of the specific tool or

Subcolumns of column 4 are as follows:

test equipment.

C-Operator/Crew

Tool Number.

This column lists the

O-Organizational

manufacturer's part number of the tool followed by the

F-Direct Support

Federal Supply Code for manufacturers (5-digit) in

H-General Support

parentheses.

D-Depot

e. Column 5, Tools and Equipment. Column 5

C-5. Remarks (Sect. IV)

specifies by code, those common tool sets (not in-

a. Reference Code. This code refers to the Apr-

dividual tools) and special tools, test, and support

propriate item in section II, column 6.

equipment required to perform the designated function.

b. Remarks. This column provides the required

explanatory information necessary to clarify items

appearing in section II.

C-2