|
| |
TM 11-5820-890-30-5
17-17. REPLACEMENT OF REAR COVER ASSEMBLY (15A1). Continued
ITEM
ACTION
REMARKS
INSTALLATION
e. Rear cover assembly (1)
Obtain replacement rear cover
f. Flexible cable (4)
g. Eight screws
and flat washers (2)
17-18.
Tools:
REPLACEMENT
assembly.
Align and install flexible cable in LS-671/VRC
CCA connector and push down on outside
of connector to secure flexible cable.
Turn rear cover assembly over and
aline on case (3).
Using cross tip screwdriver, install and
hand tighten eight retained screws and
flat washers securing rear cover assembly
(1) to case (3). Using torque screwdriver,
torque screws to 15 in-lb.
OF CASE/FLEXIBLE CABLE ASSEMBLY.
Cross tip screwdriver
Soldering kit
Torque screwdriver
1/16-inch alien wrench
Expendable Supplies:
Solder
Cotton swabs
Alcohol
References:
Paragraph 17-17 for removal and installation of the rear cover assembly (15A1).
ITEM
ACTION
REMARKS
REMOVAL
a. Rear cover assembly (1)
Remove and retain rear cover
Refer to paragraph 17-17
assembly.
for rear cover assembly
removal instructions.
Using cross tip screwdriver, remove and
See figure 17-4.
retain six screws and flat washers securing
speaker cover (6) to case (3). Remove
and retain speaker cover.
b. Six screws, flat
washers (5), and
speaker cover (6)
17-26
|
