|
| |
TM 11-5820-890-30-5
16-16. REPLACEMENT OF THREADED SCREW INSERTS. Continued
ITEM
ACTION
REMARKS
INSTALLATION Continued
e. Prewinder (4)
f. Insert (5)
g. Tang breakoff
tool (7)
Loosen stop collar (6) with hex wrench.
If insert is used with a cap-
Extend threaded shaft beyond end of
tive screw, set prewinder
prewinder one thread longer than insert.
with an extra 2 to 3 mm
Move stop collar to top of tool body and
length.
tighten. Retract threaded shaft.
Place insert in prewinder (4) with tang
end toward prewinder tip. Rotate shaft
until insert projects beyond the tip one
full turn. Place tip in hole. Screw insert
into hole until stop collar touches the
tool body. Retract prewinder.
Place on tang. Break off tang by pressing
down on tool. Remove tang breakoff tool.
Remove broken tang from hole.
Figure 16-4. Threaded Screw Insert Replacement
16-20
|
