|
| |
TM 11-5820-890-30-5
16-15. REPLACEMENT OF WIRING. Continued
ITEM
ACTION
REMARKS
INSTALLATION Continued
NOTES:
1. Using the wire stripper, strip 3.5 mm of insulation from one end of wire #006.
Using the wire stripper, strip 20.0 mm of insulation from other end of wire #006.
Using the soldering kit, tin both ends of wire #006. Insert the 20.0 mm end of wire
#006 through top terminals of filters FL1 and FL2 (20) and (21). Place a 12.0 mm
length of 16 gauge insulation sleeving on wire #006 between terminals of filters
FL1 and FL2 (20) and (21).
2. Using the wire stripper, strip 3.5 mm of insulation from one end of wire #031.
Using the wire stripper, strip 20.0 mm of insulation from other end of wire #031.
Using the soldering kit, tin both ends of wire #031. Insert the 20.0 mm end of wire
#031 through bottom terminals of filters FL1 and FL2 (20) and (21). Place a 12.0
mm length of 16 gauge insulation sleeving on wire #031 between terminals of
filters FL1 and FL2 (20) and (21).
3. Connect wire #032 to shields of wires #018, 019, and, 024 going directly from
shield to shield. Cover all J5 pigtail connections with heat shrinkable insulation
sleeving. Cover exposed braid on end opposite pigtail connection of wires #018,
019, and 024 with heat shrinkable insulation sleeving. Cover all J3 and J4 con-
nections with 14 gauge insulation sleeving.
d. Wiring Continued
Using wire stripper, strip wires. Using
cotton swabs and alcohol, clean wires.
Using soldering kit, tin wires.
e. Shielded electrical cables
Prepare wires #018, 019, and 024 as
follows: Unbraid shielding from around
center conductor. Using cotton swabs
and alcohol, clean the shielding. Using
soldering kit, tin the shielding. Using
wire stripper, strip sleeving from center
conductor. Using cotton swabs and
alcohol, clean the center conductor.
Using soldering kit, solder wires as
specified in the wire list.
f. J5 connector (16)
If applicable install J5 connector.
Refer to paragraph 16-12
for installation instructions.
16-18
|
