|
| |
TM 11-5820-890-30-5
15-33.
Tools:
REPLACEMENT OF BATTERY
Flat tip screwdriver
Cross tip screwdriver
Spanner wrench
Spanner wrench adapter
Flat tip adapter
Expendable Supplies:
Silicone compound
References:
Paragraph
Paragraph
Paragraph
Paragraph
Paragraph
Paragraph
Paragraph
Paragraph
Paragraph
Paragraph
Paragraph
Paragraph
Paragraph
Paragraph
Paragraph
TRAY CASE.
Torque screwdriver
Socket wrench
Torque wrench
Pocket knife
7/16 inch open-end wrench
9/16 inch open-end wrench
9/16 inch socket
7/8 inch socket
15-20 for removal and installation of mounting plate assembly.
15-21 for removal and installation of battery tray gasket.
15-22 for removal and installation of A1 battery tray CCA.
15-23 for removal and installation of A2 connector board CCA and P1 connector.
15-24 for removal and installation of R1 resistor.
15-25 for removal and installation of VR1 zener diode.
15-26 for removal and installation of J1 connector.
15-27 for removal and installation of U1 voltage regulator.
15-28 for removal and installation of E1 terminal lug.
15-30 for removal and installation of DS1 Iamp holder.
15-31 for removal and installation of seal screw.
15-32 for removal and installation of S1 pushbutton switch.
15-33 for removal and installation of A2 connector board CCA.
15-34 for removal and installation of battery box gasket.
15-35 for removal and installation of threaded screw inserts.
ITEM
ACTION
REMARKS
REMOVAL
a. Mounting plate
assembly (2)
b. Battery tray
subassembly (1)
c. J1 connector (5)
d. U1 voltage regulator (10)
e. A2 connector board CCA
(13) and P1 connector (17)
f.
Light lens
g. DS1 Iamp holder (14)
15-36
Remove and retain.
Set upside down on work surface with
left side toward you.
Remove and retain.
Remove and retain.
Remove and retain.
Remove light lens from DS1 lamp holder
(14). Inspect it for damage. If damaged,
obtain replacement.
Remove and retain.
Refer to paragraph 15-20
for removal of mounting
plate assembly.
Refer to paragraph 15-26
for removal of J1
connector.
Refer to paragraph 15-27
for removal of U1 voltage
regulator.
Refer to paragraph 15-33
for removal of A2 connector
board CCA and P1
connector.
Refer to paragraph 15-30
for removal of DS1 lamp
holder.
|
