Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: REPLACEMENT OF WIRING IN POWER SUPPLY ADAPTER CHASSIS (8A2). Continued
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 



TM 11-5820-890-30-5 14-41. REPLACEMENT OF WIRING IN POWER SUPPLY ADAPTER CHASSIS (8A2).  Continued ITEM ACTION REMARKS INSTALLATION  Continued j. k. l. m. Terminal  post Tiedown  straps  (11) Rear  access  cover  (2) 12   captive screws  (11) Section V. Use  soldering  kit,  soldering  aid,  heat Before  and  after  soldering, sink,  and  long  nose  pliers.  Wrap  and clean  wires  and  terminal solder  end  of  replacement  wire  on post  with  alcohol  and terminal   post. cotton  swabs. Install  replacement  tiedown  straps  on  wiring harness,  and  remove  wire  tags. Position  replacement  rear  access  cover  on the  power  supply  adapter  chassis.  See figure  14-7. Use  flat  tip  screwdriver.  Install  and  hand tighten  the  12  captive  screws  securing the  rear  access  cover  on  the  chassis. Use  torque  screwdriver.  Torque  to  9  in-lb. PREPARATION  FOR  STORAGE  OR  SHIPMENT 14-42. GENERAL INFORMATION. a. Pack  the  power  supply  adapter  and  any  removed  modules  in  approved  shipping  containers. b. All  modules  must  be  shipped  enclosed  in  material  that  provides  protection  from  static  electricity.  See the  following  paragraph. 14-43. PACKING STATIC SENSITIVE MODULES. The  following  steps  should  be  followed  when  packing  a  static  sensitive  module  for  storage  or  shipment. CAUTION To avoid damaging static sensitive modules, use an antistatic pad on the work surface and wear a  grounded  wrist  strap  when  handling  the  module. ITEM ACTION REMARKS a.  Module  (1) Place  inside  antistatic  bag  (2)  or  inside antistatic  wrapping  material  (3).  See figure  14-12. b.   Antistatic   package   (4) Seal  with  adhesive  tape.  Attach “sensitive   electronic   devices”   unit pack  label  (5). c.   Antistatic   package   (4) Place  inside  approved  shipping  container  (6). Attach   “sensitive   electronic   devices” intermediate  pack  label  (7). 14-76


Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business