|
| |
TM 11-5820-890-30-5
14-36. REPLACEMENT OF LAMP HOLDER FOR DS1 LAMP. Continued
ITEM
ACTION
REMARKS
INSTALLATION
g.
Lamp holder (13)
h.
O-ring
i. Hex nut and
Iockwasher
j.
Lamp holder (13)
wires
k.
Light lens and
DS1 lamp
l. Heat sink
assembly
14-37. REPLACEMENT
Tools:
OF E1
Flat tip screwdriver
Torque screwdriver
Flat tip bit
Torque wrench
Expendable Supplies:
Solder
Silicone compound
References:
Obtain replacement lamp holder, hex nut,
and Iockwasher.
Apply silicone compound to o-ring on
replacement lamp holder.
Use 9/16 inch wrench. Install and hand
tighten replacement hex nut and Iockwasher
securing lamp holder to chassis.
Use torque wrench. Torque to 30 in-lb.
Use soldering kit, soldering aid, and heat
Before and after soldering,
sink. Solder wires to tagged terminals on
clean wires and lamp
the lamp holder, and remove the tags.
holder terminals with
alcohol and cotton swabs.
Install and tighten retained light lens on
the lamp holder.
Install retained heat sink assembly on
Refer to paragraph 14-17
power supply adapter chassis (1).
for heat sink installation.
OR E2 BINDING POST.
Soldering kit
Soldering aid
Heat sink
5/16 inch wrench
Alcohol
Cotton swabs
Paragraph 14-17 for removal and installation of the heat sink assembly (8A1).
ITEM
ACTION
REMARKS
REMOVAL
a.
Heat sink assembly (2)
Remove and retain heat sink assembly
Refer to paragraph 14-17
from power supply adapter chassis (1),
for heat sink removal.
See figure 13-2.
b. Power supply adapter
Set upside down on work surface with
chassis (1)
front toward you. See figure 13-6.
14-57
|
