|
| |
TM 11-5820-890-30-5
14-29. REPLACEMENT OF CR3 AND CR4 DIODE ANGLE BRACKET. Continued
ITEM
ACTION
REMARKS
INSTALLATION
h.
Angle bracket
Iockwashers
i.
Three screws,
washers, and
Iockwashers (12)
j.
CR3 diode (4)
k.
CR4 diode (4)
(11) and
Obtain replacement angle bracket and
Iockwashers.
flat
Use cross tip screwdriver. Install and
tighten three retained screws, flat washers,
and replacement Iockwashers securing the
angle bracket (11) to the power supply
adapter chassis.
l.
Rear access cover
m. 12 captive
screws (3)
Install CR3 on angle bracket. Use 1/4 inch
wrench. Install and tighten retained hex
nut (8), terminal lug (7), flat washer (9),
insulated washer (10), and mounting
pad (6) securing the diode to the angle
bracket (11) on the power supply adapter
chassis.
Install CR4 on angle bracket. Use 1/4 inch
wrench. Install and tighten retained hex
nut (8), terminal lug (7), flat washer (9),
insulated washer (10), and mounting
pad (6) securing the diode to the angle
bracket (11) on the power supply adapter
chassis.
Position retained rear access cover
on the power supply adapter chassis.
Use flat tip screwdriver. Install and hand
tighten the 12 captive screws securing
the rear access cover to the power
supply adapter chassis. Use torque
screwdriver. Torque to 9 in-lb.
14-48
|
