|
| |
TM 11-5820-890-30-5
14-25. REPLACEMENT OF J2 CONNECTOR. Continued
ITEM
ACTION
REMARKS
INSTALLATION
g.
h.
i.
Connector (1) and
Obtain replacement connector and
Iockwasher
O-ring
Spanner nut
and Iockwasher
Iockwasher.
Apply silicone compound to o-ring
on replacement connector.
Use 1 5/16 inch spanner wrench.
j.
Connector (1) wires
k.
l.
Rear access cover
screws (3)
(2)
Install and hand tighten retained
spanner nut and replacement Iockwasher
securing the connector to power supply
adapter chassis. Use torque wrench and
socket wrench spanner attachment.
Torque to 90 in-lb.
Use soldering kit, soldering aid, and
heat sink. Solder tagged wires to
correct connector pins, and remove
wire tags.
Position retained rear access cover on
the power supply adapter chassis.
Use flat tip screwdriver. Install and hand
tighten the 12 captive screws securing
the rear access cover to the power
supply adapter chassis. Use torque
screwdriver. Torque to 9 in-lb.
Before and after soldering,
clean wires and connector
pins with alcohol and
cotton swabs.
14-41
|
