|
| |
TM 11-5820-890-30-5
12-9. ELECTRICAL FILTER ASSEMBLY REPAIR PROCEDURE.
Tools:
Tool Kit, Electronic Equipment, TK-105/G
Torque wrench
Torque adapter
ITEM
ACTION
REMARKS
DISASSEMBLY
a.
b.
c.
d.
Six captive screws
Electrical connectors
J1 and J2
Filter support
plate (7)
Electrical connector J3
ASSEMBLY
e.
f.
g.
h.
Electrical connector J3
Filter support
plate (7)
Electrical connectors
J1 and J2
Six captive screws
Fully loosen. Lift cover off at case.
See figure 12-2 for parts
identification.
Unsolder wires. Loosen and remove
locking rings on connectors. Remove
from cover.
Remove four screws and lift free
of the case.
Remove two screws and lift J3 free
of case. Unsolder the wire attached
to post 5.
Solder the wire attached to post 5.
Before and after soldering,
Place connector J3 in position in
clean wires and leads with
the case. Install and tighten two
cotton swabs and alcohol.
screws. Torque to 9 in-lb.
Position on case. Install and tighten
four screws. Torque to 9 in-lb.
Position on cover. Install and tighten
locking rings on connectors. Solder
wires in place.
Place cover on case. Tighten captive
screws. Torque to 9 in-lb.
Section V. PREPARATION FOR STORAGE OR SHIPMENT
12-10. GENERAL INFORMATION.
Pack the COMSEC mount in an approved shipping container.
12-5
|
