Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: REPLACEMENT OF BATTERY BOX COVER (cont)
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 



TM 11-5820-890-30-5 8-12. REPLACEMENT OF BATTERY BOX COVER. Tools: Cross  tip  screwdriver Pocket  knife References: Paragraph  8-21  for  removal  and  installation  of  dampening  tape  gasket. ITEM ACTION REMARKS REMOVAL a.   Two   battery   box   cover Release  two  twist  lock  latches  securing latches  (32) battery  box  cover  (1)  to  battery  box case  (15).  See  figure  8-3. b.   Four   screws   (11),   flat Use  cross  tip  screwdriver.  Remove  and washers  (13),  and  lock- retain  two  screws  (11),  flat  washers  (13), washers  (12) and  Iockwashers  (12)  securing  each  latch (32)  to  battery  box  cover  (1).  Remove and  retain  two  latches  (32). c.   Dampening   tape Remove  and  retain. gaskets  (3) d.   Battery   box   cover   (1) Discard. INSTALLATION e.   Battery   box   cover   (1) Obtain   replacement. f.   Dampening   tape Install. gaskets  (3) g.   Battery   box   cover   (1) Place  on  battery  box  case  (15). Refer  to  paragraph  8-21  for removal   procedures. Refer  to  paragraph  8-21  for installation   procedures. NOTE If  replacing  latch/strike assembly  equipped  with battery  box  cover  retaining ring  (24),  insure  retaining ring  is  properly  positioned under   latch/strike   assembly before   proceeding   to step  h. NOTE h.  Two  battery  box  cover Position  two  retained  latches  on  cover  (1),      Do  not  over  tighten  screws latches  (32) Use  cross  tip  screwdriver.  Install  two  re- securing  latches  to  cover. tained  screws  (11),  flat  washers  (13), and  Iockwashers  (12)  securing  latches  to battery  box  cover  (1). i. Two  battery  box  cover Fasten  two  twist  lock  latches  securing latches  (32) battery  box  cover  (1)  to  battery  box case   (15). 8-9


Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business