| |
TM 11-5820-890-30-5
7-13. REPLACEMENT OF FL1 FILTER. Continued
ITEM
ACTION
REMARKS
INSTALLATION Continued
i.
j.
k.
l.
m.
n.
o.
Filter mounting plate (22)
Hex nut (27) and
Iockwasher (26)
FL1 filter (20) terminals
FL1 filter (20) wires
Filter mounting plate
Three screws (25),
Iockwashers (24),
and flat washers (23)
(22)
Eight screws (5)
and Iockwashers (6)
Install FL1 filter (20) in mounting
hole of filter mounting plate (22).
Use 5/16-inch wrench. Install and
hand tighten hex nut (27) and lock-
washer (26) securing FL1 filter (20)
to filter mounting plate (22).
Using cotton swabs and alcohol,
clean both terminals on FL1 filter (20).
Use soldering kit. Solder wires to correct
terminals of FL1 filter (20).
Position filter mounting plate (22) in
connector case (12).
Use cross tip screwdriver. Install and
tighten three screws (25), Iockwashers
(24), and flat washers (23) securing
filter mounting plate (22) to connector
case (12).
Use cross tip screwdriver. Install and
hand tighten eight screws (5) and
Iockwashers (6) securing access
cover (1) to connector case (12).
Use torque screwdriver. Torque
screws to 8 to 10 in-lb.
7-14. REPLACEMENT OF FL2 FILTER.
Tools:
Cross tip screwdriver
Soldering kit
3/8-inch wrench
Expendable supplies:
Solder
Cotton swabs
Alcohol
References:
Paragraph 7-10 for removal and installation of connector case.
If a screw is not stripped
but will not tighten, inspect
its tapped hole. If the tap-
ped hole is defective, refer
to paragraph 7-10 for re-
placement of connector
case (12).
If a screw is not stripped
but will not tighten, refer
to paragraph 7-16 for
replacement of its threaded
screw insert (if present).
If a tapped hole is defec-
tive, refer to paragraph
7-10 for replacement of
the connector case. (12).
Paragraph 7-16 for removal and installation of threaded screw inserts.
7-14
|