|
| |
TM 11-5820-890-30-5
4-67. REPLACEMENT OF SIDE PANEL.
Tools:
Cross tip screwdriver
Torque screwdriver
1/2-inch open-end wrench
Flat tip screwdriver
Adjustable wrench
Hex wrench
ITEM
ACTION
REMARKS
REMOVAL
a. Mounting adapter
Set on work surface with left side
toward you.
b. Two screws (5)
Using cross tip screwdriver, remove and
See figure 4-20.
retain two screws (5) securing side panel
(6) to power supply chassis (15).
c. Nine screws (7 and 8)
Using cross tip screwdriver, remove and
retain nine screws (7 and 8) securing top
shelf (9) to mounting adapter.
d. Mounting rail (4)
Using cross tip screwdriver, remove and
See figure 4-19.
retain seven screws (3) securing mount-
ing rail (4) to defective side panel (1).
Remove and retain mounting rail (4).
e. J1 protective cap (29)
Using cross tip screwdriver, remove and
retain screw (7) and flat washer securing
J1 protective cap (29) to defective side
panel (1). Remove and retain J1
protective cap.
f. Shoulder pin (6)
g. Side panel (1)
Using adjustable wrench and 1/2-inch open-
end wrench, remove and retain hex nut
(5), Iockwasher, and flat washer securing
shoulder pin (6) to side panel (1).
Remove and retain shoulder pin.
Using cross tip screwdriver, remove and
retain four screws (2) securing defective
side panel to power control chassis (8).
Remove and discard defective side panel.
4-181
|
