|
| |
TM 11-5820-890-30-5
2-54. REPLACEMENT OF OBSERVATION WINDOW.
In order to replace the observation window, perform the procedure in paragraph 2-53 for replacement of the
front panel; but, instead of replacing the front panel, replace the observation window.
Section V.
Subject
General Information . . . . . . . . . . .
Packing Static Sensitive Modules
PREPARATION FOR STORAGE OR SHIPMENT
Para
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-55
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-56
Page
2-188
2-188
2-55. GENERAL INFORMATION.
a.
Pack the RT and modules in approved shipping containers.
b.
All modules must be shipped enclosed in material that provides protection from static electricity. See
the following paragraph.
2-56. PACKING STATIC SENSITIVE MODULES.
The following steps should be followed when packing a static sensitive module for storage or shipment.
CAUTION
To avoid damaging static sensitive modules, use an antistatic pad on the work surface and wear
a grounded wrist strap when handling the module.
ITEM
ACTION
REMARKS
a. Module (1)
Place inside antistatic bag (2)
or inside antistatic wrapping
material (3). See figure 2-21.
b. Antistatic package (4)
Seal with adhesive tape. Attach
“static sensitive contents” unit
pack label (5).
c. Antistatic package (4)
Place inside approved shipping
container (6). Attach “static
sensitive contents” intermediate
pack label (7).
2-188
|
