|
| |
TM 11-5820-890-30-5
2-48. REPLACEMENT OF THREADED SCREW INSERTS. Continued
ITEM
ACTION
REMARKS
INSTALLATION
c. Prewinder (4) and
insert (5)
d. Tang breakoff tool (7)
Figure
Loosen stop collar (6) with hex wrench.
If insert is used with
Extend threaded shaft beyond end of
a captive screw, set
prewinder one thread longer than insert.
prewinder with an extra
Move stop collar to top of tool body and
2 to 3 mm length.
tighten. Retract threaded shaft. Place
insert in prewinder with tang end toward
prewinder tip. Rotate shaft until insert
projects beyond the tip one full turn.
Place tip in hole. Screw insert into hole
until stop collar touches tool body. Re-
tract prewinder.
Place on tang. Break off tang by pressing
down on tool. Remove tang breakoff tool.
Remove broken tang from hole.
2-19. Threaded Screw Insert Replacement
2-176
|
