|
| |
TM 11 5820 890 20 2
B 1
APPENDIX B
MAINTENANCE ALLOCATION CHART
Section I. INTRODUCTION
B.1. GENERAL.
a. This section provides a general explanation of all maintenance and repair functions authorized at various
maintenance categories.
b. The Maintenance Allocation Chart (MAC) in section II designates overall authority and responsibility for
the performance of maintenance functions on the identified end item or component. The application of the
maintenance functions to the end item or component will be consistent with the capacities and capabilities of the
designated maintenance levels.
c. Section III lists the tools and test equipment (both special tools and common tool sets) required for each
maintenance function as referenced from Section II.
d. Section IV contains supplemental instructions and explanatory notes for a particular maintenance
function.
B.2. MAINTENANCE FUNCTIONS.
a. Inspect. To determine the serviceability of an item by comparing its physical, mechanical, and/or
electrical characteristics with established standards through examination; e.g., by sight, sound, or feel.
b. Test. To verify serviceability by measuring the mechanical, pneumatic, hydraulic, or electrical
characteristics with established standards through examination; e.g., by sight, sound, or feel.
c. Service. Operations required periodically to keep an item in proper operating condition; i.e., to clean
(includes decontaminate, when required), to preserve, to drain, to paint, or to replenish fuel, lubricants, chemical
fluids, or gases.
d. Adjust. To maintain or regulate, within prescribed limits, by bringing into proper or exact position, or by
setting the operating characteristics to specified parameters.
e. Calibrate. To determine and cause corrections to be made or to be adjusted on instruments or test,
measuring, and diagnostic equipments used in precision measurement. Consists of comparisons of two
instruments, one of which is a certified standard of known accuracy, to detect and adjust any discrepancy in the
accuracy of the instrument being compared.
f.
Remove/Install. To remove and install the same item when required to perform service or other
maintenance functions. Install may be the act of enplacing, seating, or fixing into position a spare, repair part, or
module (component or assembly) in a manner to allow the proper functioning of an equipment or system.
g. Replace. To remove an unserviceable item and install a serviceable counterpart in its place. •Replace"
is authorized by the MAC and is shown as the third position code of the SMR code.
h. Repair. The application of maintenance services1, including fault location/troubleshooting2,
removal/installation, and disassembly/assembly3 procedures, and maintenance actions4 to identify troubles and
restore serviceability to an item by correcting specific damage, fault, malfunction, or failure in a part, subassembly,
module (component or assembly), end item, or system.
|
