|
| TM 11-5820-890-10-8
Send an ERF as Part of RXMT Operation (Special Operator Task 7)
5.5j.
This is not a normal operator task. It is performed only as part of an
DESCRIPTION
RXMT operation. When operators are required to perform RXMT
operations, it may be necessary for them to send an ERF to the distant
station in order to establish FH communications. Sending an ERF
requires the sending operator to change from FH to FH-M, with
associated risk to net sync time if the operator fails to return to FH
immediately after sending the ERF. The ERF procedure is known by all
NCS personnel, thus the RXMT operator should be able to obtain
verbal help if needed.
DETAILED FLOWCHART
RESULTS
SUBTASKS
ACTIONS
If not already loaded, load
a.
(If net ID only, see Special Operator
Obtain data to be sent
ERF data in RT-D*
Task 8 for details)
by ERF
Alert RT-B RXMT data is
b. Contact distant station
(ERF is sent on operational channel
being sent by ERF
used for the alert)
(1)
Set FCTN to LD
c.
Prepare RT to send ERF
N/A
(2)
Set MODE to FH-M**
N/A
(1)
Press [LOAD] on RT
Display shows "HLD _"
d. Send ERF
keypad
(2)
Enter channel where data
Display shows "HF XXX"
IS stored
(3)
Press [ERF] on RT
Display shows "SEND"
keypad
e. Make communications
(1)
Wait for distant station
(20-30 seconds should be adequate)
(RT-B) to store the ERF
check
(2)
Call RT-B and confirm
(Obtain ACK from all operators who
that ERF was received
were to receive the ERF)
5-58
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |