|
| TM 11-5820-890-10-8
4.10b. SINCGARS Low-Profile Antenna (SLPA) (AS-3916)
SOURCE
The SINCGARS Low-Profile Antenna, or SLPA for short, is a part of
selected vehicular radio installation kits. Refer to SB 11-131-2 for
listings of individual kits.
EMPLOYMENT
The SLPA is designed to reduce antenna visibility, and it withstands tree
limb strikes better than the regular antenna. There is a slight reduction
in operating range of the radio when the SLPA is employed. Both
regular and SLPA antennas are provided for selected combat vehicles,
tanks for example.
SAFETY
Safety precautions pertaining to the employment of vehicle antennas
are repeated here for sake of emphasis.
WARNING
DEATH OR SERIOUS INJURY CAN OCCUR IF THE ANTENNA COMES
INTO CONTACT WITH OVERHEAD POWER LINES
Do not stop your vehicle under power lines.
When mobile, never pass under power lines if there is any doubt about overhead
clearance.
If you are not sure that an antenna on your vehicle will clear a power line, stop before
you get close to the power fine and either carefully tie down the antenna or, if
necessary, remove the antenna to make sure that you can safely drive under the power
line.
During cross -country operations, do not allow anyone to stick an arm, leg, or weapon
over the sides of the vehicle. If your antenna accident/y touches a power fine,
individuals who are in contact with vegetation or the ground could suffer death or sever
injury.
for additional safety information, refer to TB-43-0129, "Safety Requirements for Use
of Antenna and Mast Equipment. "
Figure 4-22. VEHICULAR ANTENNA SAFETY PRECAUTIONS
4-33
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |