Click here to make tpub.com your Home Page

Page Title: Table 4-3. Checkout/Troubleshoot the Antenna Coupler CU-2229/URC -92--Continued
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 



TM 11-5820-873-34
Table 4-3 Checkout/Troubleshoot the Antenna Coupler CU-2229/URC- 92-Continued
STEP
ACTION
INDICATION
NEXT STEP
83
Check that 2S3 C MIN switch is not activated and
2S3 checks good
Yes: reinstall
that 2S3 contacts are open
removed com-
ponents. go to
step 139
No: reinstall removed
components Re-
place switch 2S3,
perform C MIN
and C MAX
adjustment
84
Check that 2S4 C MAX switch Is not activated
2S4 checks good
Yes: reinstall
and that 2S4 contacts are open
removed com-
ponents. go to
step 139
No: reinstall removed
components Re
place 2S4, per-
form C MIN and
C MAX adjust-
ment
85
Perform Amplitude Detector Adjustment
Amplitude Detector adjusts to within tolerance
Yes: reinstall
removed com-
ponents, go to
step 3a.
No: reinstall removed
components, go
to step 143
86
Set mode switch to OFF Check wiring for contin-
Wiring checks good
Yes: reinstall
uity and shorts to ground between 2J2 and
removed com-
2A3-E3 and between 2A3-E4 and 2XA1-B
ponents, go to
step 144
No: reinstall removed
components, go
to step 139
87
Set mode switch to OFF. Disconnect connector
Meter indicates 0 VDC 0.5 VDC
Yes: reinstall
from Servo Control Assy 2A6 Set mode switch
removed com-
to AM. Connect VTVM between 2XA6-M and
ponents, go
ground.
to step 142
No: reinstall removed
components, go
to step 140
88
Perform Phase Detector Adjustment
Phase Detector adjusts to within tolerance
Yes: step 3a
No: reinstall removed
components, go
to step 143
89
Set mode switch to OFF Remove Control Logic
Meter indicates + 10 VDC 0.8 VDC
Yes: step 140
CCA 2A1 Set mode switch to CPLR TUNE KW
No: step 90
Connect VTVM between 2XA1-2 and ground
90
Continuity check the following
Continuity checks good
Yes: replace
2A3-E8 to 2K1-12
2K1 Reinstall
2K1-8 to2XA1-2
removed
components
No: reinstall removed
components, go
to step 139
91
COUPLER STATUS FAULT indicator s lit
Yes: step 92
No: step 101
92
Set frequency to 15.602
NOTE
If the time delay runs out during this test, de-
Yes: step 93
press TUNE START again If tuning occurs the
No: step 102
second time the Indication is good
Antenna Coupler completes tune cycle and
Yes: step 93
COUPLER STATUS READY indicator illuml-
No: step 102
nates
4-28


Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business