 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|  TM 11-5820-670-30
2-58. A6500 ASSEMBLY REPLACEMENT. (CONT)
REMOVAL
1.
Using screwdriver, loosen two captive screws (1) and lower A4500 assembly (2).
Disconnect white wire (P6502) (3) from J6502.
2.
Disconnect gray wire (P6001) (4) from J6001.
3.
Using screwdriver, loosen two captive screws (5) and unplug connector P6503 (6) from
4.
J6503 (7).
5. Using screwdriver, remove screw (8) from chassis.
6. Using screwdriver, remove three shouldered screws (9) and swing out A9500 assembly (10).
7. Using screwdriver, remove screw (11) from chassis.
8. Using screwdriver, remove two screws (12) from upper support.
9. Pull A6500 assembly straight back to disconnect from mechanical linkage as shown in detailed
view.
INSTALLATION
NOTE
Use care when performing next step so as not to disturb positioning of mechanical link-
age couplers.
1. Install A6500 assembly, alining couplers as shown in detailed view.
2. Install two screws (12) and, using screwdriver, tighten.
3. Install screw (11) and, using screwdriver, tighten.
4. Swing A9500 assembly (10) closed and install three shouldered screws (9).
5. Using screwdriver, tighten three shouldered screws (9).
6. Install screw (8) and, using screwdriver, tighten.
7. Plug connector P6503 (6) into J6503 (7).
8. Using screwdriver, tighten two captive screws (5).
9. Connect gray wire (P6001) (4) to J6001.
10. Connect white wire (P6502) (3) to J6502.
11. Raise A4500 assembly (2).
12. Using screwdriver, tighten two captive screws (1).
FOLLOW-ON MAINTENANCE: Install case (para 2-39).
2-197
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals