INSTALLATION-continued - TM-11-5820-670-300267

TM 11-5820-670-30

2-45. A8700 MODULES AND ASSEMBLY REPLACEMENT. (CONT)

NOTE

Filter module is secured with locknuts and is soldered to printed circuit board.

Module location is stamped on board.

Position module (8) on board and install locknuts (9).

Using wrench, tighten locknuts (9).

CAUTION

Care must be taken when performing next step to prevent damaging printed circuit

board.

Using soldering iron, solder pins (10) of module (8) to printed circuit board.

CAUTION

Before installing modules, ensure pins on assembly are not bent. Straighten any bent

pins. Extreme care must be taken not to damage pins.

NOTE

Modules A8100 through A8400 and A8600 are secured with captive screws. Steps 9 and

10 are typical for all modules.

Module location is stamped on board.

Carefully position module (11) on pins (12) and push into place.

Using screwdriver, tighten captive screws (13).

10.

2-175