Figure 3-2 Traveling station (1,000-watt) interconnections.

TM 11-5820-554-12

the mount plugs have entered the transceiver sockets.

power supply to the transceiver when the Collins

Tighten the wingnuts on the sides of the transceiver.

351D-2 is not used.

See the Collins 351D-2 instruction sheet for mobile

CAUTION

mount installation.

Before making connections to the auto-

(1) Select a location in the car for mounting the

mobile electrical system, make sure that

Collins MP-1. This location must be as clean and dry

the primary circuits in the Collins MP-1

as possible. Location in the luggage compartment

are connected for proper ground polarity.

under the seat or on the passenger side of the fire wall

Correct connections for either positive or

is satisfactory. DO NOT mount in the engine

negative ground systems are shown in

compartment.

(2) Determine the length of power cable needed

(3) If operation is to be in a boat or plane having a

(furnished with the Collins 351 D-2) to connect the

115-volt 400-Hz power supply, use the PP-

4151/FRC-93 with C1 (0.05 f) removed from across

Collins MP-1 to the Collins KWM-2/ 2A, and cut to

the required length. Connect the power supply,

L1 in the filter circuit. If the operation is to be in a

speaker, and microphone (fig. -3). The Collins 440E-

boat or plane having a 24-volt d.c. power

1 may be used to connect the

ELODOOO2

Figure 3-2 Traveling station (1,000-watt) interconnections.

3-4