SECTION I. INTRODUCTION - TM-11-5820-535-24P0005

TM 11-5820-535-24P

SECTION I

INTRODUCTION

1. Scope

NOTE

This manual lists spares and repair parts; special tools;

Cannibalization or salvage may be used as a

special test, measurement, and diagnostic equipment

source of supply for any items source coded

(TMDE),and other special support equipment required for

above except those coded XA and aircraft sup-

performance of organizational, direct support, and general

port items as restricted by AR 700-42.

support maintenance of the AN/TRC-110(V). It authorizes

(2) Maintenance code. Maintenance codes are

the requisitioning and issue of spares and repair parts as

assigned to indicate the levels of maintenance authorized

indicated by the source and maintenance codes.

to USE and REPAIR support items. The maintenance

codes are entered in the third and fourth positions of the

2. General

Uniform SMR Code format as follows:

This Repair Parts and Special Tools List is divided into the

(a) The maintenance code entered in the third

following sections:

position will indicate the lowest maintenance level

a. Section II. Repair Parts List. A list of spares and

authorized to remove, replace, and use the support item.

repair parts authorized for use in the performance of

The maintenance code entered in the third position will

maintenance. The list also includes parts which must be

indicate one of the following levels of maintenance:

removed for replacement of the authorized parts. Parts

Code

Application/Explanation

lists are composed of functional groups in numeric

O -Support item is removed, replaced, used at the

sequence, with the parts in each group listed in figure and

organizational level.

item number sequence.

F -Support item is removed, replaced, used at the direct

b. Section III. Special Tools List. Not applicable.

support level.

c. Section IV. National Stock Number and Part Number

(b) The maintenance code entered in the fourth

Index. A list, in National item identification number (NIIN)

position indicates whether the item is to be repaired and

sequence, of all National stock numbers (NSN) appearing

identifies the lowest maintenance level with the capability

in the listings, followed by a list, in alphanumeric sequence,

to perform complete repair (i.e., all authorized

of all part numbers appearing in the listings. National

maintenance functions). This position will contain one of

stock numbers and part numbers are cross-referenced to

the following maintenance codes:

each illustration figure and item number appearance.

Code

Application/Explanation

3. Explanation of Columns

O -The lowest maintenance level capable of complete

a. Illustration. This column is divided as follows:

repair of the support item is the organizational

(1) Figure number. Indicates the figure number of

level.

the illustration on which the item is shown.

F -The lowest maintenance level capable of complete

(2) Item number. The number used to identify item

repair of the support item is the direct support

called out in the illustration.

level.

b. Source; Maintenance, and Recoverability (SMR)

D -The lowest maintenance level capable of complete

Codes.

repair of the support item is the depot level.

(1) Source code. Source codes indicate the manner

Z -Nonreparable. No repair is authorized.

of acquiring support items for maintenance, repair, or

(3) Recoverability code. Recoverability codes are

overhaul of end items. Source codes are entered in the

assigned to support items to indicate the disposition action

first and second positions of the Uniform SMR Code for-

on unserviceable items. The recoverability code is entered

mat as follows:

in the fifth position of the Uniform SMR Code format as

Code

Definition

follows:

PA -Item procured and stocked for anticipated or known

Recoverability

usage.

codes

Definition

PD -Support item, excluding support equipment, procured

Z -Nonreparable item. When unserviceable, condemn

for initial issue or outfitting and stocked only for

and dispose at the level indicated in position 3

subsequent or additional initial issues or outfittings.

O -Reparable item. When uneconomically reparable,

Not subject to automatic replenishment.

condemn and dispose at organizational level.

XD -A support item that is not stocked. When required,

F -Reparable item. When uneconomically reparable,

item will be procured through normal supply

condemn and dispose at the direct support level.

channels.

H -Reparable item. When uneconomically reparable,

condemn and dispose at the general support

level.