|
| TM 11-5820-509-35
APPENDIX B
DIRECT SUPPORT, GENERAL SUPPORT, AND
DEPOT MAINTENANCE REPAIR PARTS
AND SPECIAL TOOLS LIST
Section I. INTRODUCTION
B-1. Scope
This appendix lists repair parts and special tools
Code
Explanation
required for the performance of direct support, general
P2
Repair parts which are procured and stocked
support, and depot maintenance of Radio Set AN/PRC-
for insurance purposes because the combat
47.
or military essentiality of the end item
B-2. General
dictates that a minimum quantity be
available in the supply system.
This Repair Parts and Special Tools List is divided into
P9
Assigned to items which are NSA design
the following sections.:
controlled: unique repair parts, special tools,
test, measuring and diagnostic equipment'
authorized for the performance of maintenance of
which are stocked and supplied by the Army
maintenance at the direct support, general support, and
COMSEC logistic system, and which are not
depot level.
subject to the provisions of AR 380-41.
b. Special Tools, Test, and Support Equipment-
P10
Assigned to items which are NSA design
controlled special sods, test, measuring and
equipment authorized for the performance of
diagnostic equipment for COMSEC support,
maintenance at the direct support, general support, and
which are accountable under the provisions
depot level.
of AR 380-41, and which are stocked and
c. Index - Federal Stock Number and Reference
supplied by the Army COMSEC logistic
Number Cross Reference to Figure and Item Number -
system.
M
Repair parts which are not procured or
numerical sequence, followed by a list of reference
stocked, but are to be manufactured at
numbers in ascending alphanumeric sequence, cross
indicated maintenance levels.
referenced to the illustration figure number and
A
Assemblies which are not procured or stocked
reference designation.
as such but are made up of two or more
d. Index - Reference Designation Cross-Reference
unite. Such component units carry individual
stock numbers and descriptions, are
designations cross-referenced to page numbers.
procured and stocked separately, and can be
B-3. Explanation of Columns
assembled to form the required assembly at
The following provides an explanation of columns in the
indicated maintenance categories.
tabular lists
X
Parts and assemblies which are not procured
a. Source, Main tenance and Recoverability Codes
or stocked and the mortality of which
(SMR ), Column 1.
normally is below that of the applicable end
item or component. The failure of such part
(1) Source code indicates the selection status
or assembly should result in retirement of the
and source for the listed item. Source codes are:
end item from the supply system.
Code
Explanation
X1
Repair parts which are not procured or
P
Repair parts which are stocked in or supplied
stocked. The requirement for such items will
from the GSA/DSA, or Army supply system
be filled by use of the next higher assembly
and authorized for use at indicated
or component.
maintenance categories.
X2
Repair parts which are not stocked. The
indicated maintenance category requiring
such repair parts will attempt to obtain same
through cannibalization. Where such repair
parts
are
not
obtainable
through
cannibalization,
requirements
will
be
requisitioned,
with
accompanying
justification, through normal supply channels.
G
Major assemblies that are procured with PEMA
funds for initial issue only as exchange
assemblies at DSU and GSU level. These
assemblies will not be stocked above DS and
GS level or returned to depot supply level.
B-1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |