|
| TM 11-5820-401-34-3/0967-LP-432-3060
3-12. GROSS TROUBLESHOOTING PRELIMINARY INSTRUCTIONS. (CONT)
Before proceeding with the steps given in the gross troubleshooting chats, determine whether or not
the failure to the volume control test conforms to any of the following failure modes:
CORRECTION
CAUSE
FAILURE MODE
Crystal Y2012 (5.65 MHz)
Replace A2000 assembly.
No audio on all channels
in A2000 assembly
ending in "O", (eg,
30.00,30.10,30.20, etc)
Crystal Y2011 (5.60 MHz)
Replace A2000 assembly.
No audio on all channels
in A2000 assembly
ending in "5", (eg,
30.05,30.15,30.25, etc)
Defective interpolation
Replace A2000 assembly.
No audio on the same 100-
oscillator crystal
See interpolation oscil-
kHz segment for each MHz
lator crystal chart.
of tuning
INTERPOLATION OSCILLATOR CRYSTAL CHART
The following chart is used to isolate the particular crystal responsible for audio failure in the same
100-kHz segment for each MHz of tuning. In this failure mode, if audio is absent at 30.05 and 30.10,
it will be absent at 40.05 and 40.10; 50.05 and 50.10, etc.
INTERPOLATION OSCILLATOR CRYSTAL CHART
SEGMENT OF KC CONTROL
CAUSE
WHERE AUDIO IS ABSENT
CORRECTION
Crystal
Y2007
Replace
A2000
assembly.
05 and 10
Crystal
Y2008
Replace
A2000
assembly.
15 and 20
Crystal
Y2009
Replace
A2000
assembly.
25 and 30
Crystal
Y2010
Replace
A2000
assembly.
35 and 40
Crystal
Y2005
Replace
A2000
assembly.
45 and 50
Crystal
Y2004
Replace
A2000
assembly.
55 and 60
Crystal
Y2003
Replace
A2000
assembly.
65 and 70
Crystal
Y2002
Replace
A2000
assembly.
75 and 80
Crystal
Y2001
Replace
A2000
assembly.
85 and 90
Replace
A2000
assembly.
Crystal
Y2006
95 and 100
3-35
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |