|
| TB 9-2320-387-35-5
21-2. Locate, mark, and drill 0.562-in. diameter hole (7) in A-frame pillar (6).
NOTE
Wrap a section of PLGR antenna cable with tape to prevent PLGR
antenna cable from being pulled into vehicle.
21-3. Split grommet (5) and insert PLGR antenna cable (4) and grommet (5) in hole (7) in A-frame pillar (6).
21-4. Apply RTV sealant around grommet (5).
4
5
4. PLGR ANTENNA CABLE 426-0141-050 QTY. 1
6
5. GROMMET MS35489-31 QTY. 1
1.12
2.37
7
Figure 5-62.
21-5. Attach PLGR antenna (10) to support bracket (11) with screw (8) and lockwasher (9).
21-6. Attach support bracket (11) to right windshield armor plate (19) with two existing screws (12),
lockwashers (13), and washers (14).
21-7. Route PLGR antenna cable (4) along right windshield armor plate (19) with loop clamp (18),
existing screw (15), lockwasher (16), and washer (17).
21-8. Connect PLGR antenna cable (4) to PLGR antenna (10).
10
9
8
4
11
12
19
13
18
14
8.
SCREW 160046 QTY. 1
9.
LOCKWASHER 120217 QTY. 1
16 15
10.
PLGR ANTENNA AT575-030 QTY. 1
17
11.
SUPPORT BRACKET 12460300 QTY. 1
18.
LOOP CLAMP MS21333-96 QTY. 1
Figure 5-63.
5-47
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |