Attach antenna mount

TB 9-2320-387-35-5

NOTE

Do not tighten screws at this time.

9-8. Attach antenna mount (12) to rear wall of right rear wheelhouse (2) with three capscrews (13),

six lockwashers (10), three aluminum spacers (11), and nuts (9).

9-9. Temporarily install support bar (14) on antenna mounting bracket (12).

9-10. Using support bar (14) as template, locate and mark two hole locations (15). Remove support bar (14).

9-11. Drill two 0.281-in. diameter holes (15) in right rear wheelhouse (2).

NOTE

Do not tighten bolts at this time.

9-12. Attach support bar (14) to antenna support bracket with two capscrews (20), lockwashers (17), and

washers (18).

NOTE

Do not tighten capscrews at this time.

9-13. Attach support bar (14) to right rear wheelhouse (2) with two capscrews (19), washers (18),

spacers (11), lockwashers (17), and nuts (16).

9-14. Tighten top two capscrews (13) securing antenna mounting bracket (12) to right rear wheelhouse (2).

9-15. Tighten two capscrews (20) securing support bar (14) to antenna mounting bracket (12).

9-16. Tighten two capscrews (19) securing support bar (14) to right rear wheelhouse (2).

NUT 9418892 QTY. 3

10.

LOCKWASHER MS45904-72 QTY. 6

11.

SPACER 10181-5214-01 QTY. 3

12.

BRACKET, ANTENNA BASE RF292 QTY. 1

13.

CAPSCREW B1821BH031F125N QTY. 3

Figure 5-27.

5-18