Install control cable seal assembly rubber grommet

TB 9-2320-280-35-3

36-26. Install control cable seal assembly rubber grommet (40) on DVE/PTM cables (6), (8), and (9). Secure

control cable seal assembly rubber grommet (40) to tunnel rivet nuts (4) with two capscrews (38)

and washers (39).

36-27. Cover cables (6), (8), and (9) that run along vehicle exhaust pipe (10) with heat shield sleeve (41).

Secure heat shield sleeve (41) and cables (6), (8), and (9) with cable ties (42).

36-28. Route DCM/PTM interconnect cable (6) behind radio rack to DCM mounting assembly (43).

38.

CAPSCREW B1821BH025C075N QTY. 2

39.

WASHER MS27183-10 QTY. 2

41.

HEAT SHIELD SLEEVE QTY. 1

42.

STAINLESS STEEL CABLE TIE 69855K72 QTY. A/R

Figure 5-126.

Figure 5-127.

5-98