|
| TB 9-2320-280-35-2
NOTE
Procedure requires removal and reinstallation of left rear side rail,
which may require assistance. (Refer to TM 9-2320-280-20.) Perform
steps 16-3, 16-5, 16-6, 16-8, and 16-10 only for vehicles equipped
with rear side rails.
16-3. Remove left rear side rail (4).
16-4. Using mounting plate (1) as template, locate, mark, and drill four 0.343-in. diameter holes (10) and
four 0.281-in. diameter holes (16) in left rear wheelhouse (12).
16-5. Install left rear side rail (4). Do not tighten screws.
16-6. Using mounting plate (1) and left rear wheelhouse (12) as a template, drill four holes in left rear
side rail (4) from underside of left rear wheelhouse (12).
16-7. Install resilient mount (8) on mounting plate (1) with four capscrews (7), eight lockwashers (6), and
four nuts (9).
16-8. Remove paint from vicinity of eight mounting holes (16) and (10) on left rear wheelhouse (12).
Apply antiseize compound as required, position mounting plate (1) between left side rail (4)
and left rear wheelhouse (12), and align all holes.
16-9. Install mounting plate (1) on left rear wheelhouse (12) with four capscrews (5), lockwashers (14), eight
washers (15), four nuts (13), capscrews (7), eight lockwashers (6), four spacers (11), and nuts (9).
16-10. Tighten all left side rail screws.
5.
CAPSCREW B1821BH025C125N QTY. 4
6.
LOCKWASHER MS45904-72 QTY. 16
7.
CAPSCREW B1821BH031C100N QTY. 8
8.
RESILIENT MOUNT MT-6146/VSQ-1 QTY. 1
9.
NUT 9417954 QTY. 8
8
7
11.
SPACER A3046313 QTY. 4
6
13.
NUT 9419143 QTY. 4
1
14.
LOCKWASHER MS35338-44 QTY. 4
15.
WASHER 2436161 QTY. 8
~
5
4
15
6
9
15
16
6
14
7
13
4.25
12
9
6
10
11
Figure 5-52.
5-40
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |