 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|  TB 9-2320-280-35-13
NOTE
Cut split in grommet to fit cables.
29-10. Position grommet (33) over cables (6), (28), and (29).
29-11. Install grommet (33) in hole (25).
29-12. Route cables (6), (28), and (29) under fixed rear door (24) and along rear perimeter of left rear seat
back support (23). Secure cables (6), (28), and (29) to left seatback support (23) with three loop
clamps (30), screws (31), and plain-assembled nuts (32).
29-13. Route cables (6), (28), and (29) through access hole (25) and grommet (33).
29-14. Secure cables (6), (28), and (29) to left rear wheelhouse (26) with four loop clamps (30) and
self-tapping screws (27).
29-15. Take all slack out of cables and store in seat well/utility area.
29-16. Tighten screws and nuts on all clamps.
29-17. Secure right-side tunnel insulation. (Refer to TM 9-2320-280-20.)
28
29
27
6
26
30
30
27.
SELF-TAPPING SCREW 9421073 QTY. 4
28.
KDU CABLE 10511-0704-040 QTY. 1
27
29.
POWER CABLE 10181-9826-020 QTY. 1
30
30.
LOOP CLAMP MS21333-74 QTY. 7
31.
SCREW MS35206-265 QTY. 3
27
32.
NUT, PLAIN-ASSEMBLED 271166 QTY. 3
33
33.
GROMMET MS35489-24 QTY. 1
31
31
23
25
~
~
30
30
24
32
32
30
32
Figure 5-110.
5-93
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals