|
| TB 9-2320-280-35-13
NOTE
Perform step 24-10 only if not installing cargo soft-top enclosure;
otherwise, start with step 24-11.
24-10. Install antenna (25) on antenna mount assembly (23) with four capscrews (24), gasket (26), eight
lockwashers (31), and four nuts (30).
NOTE
Perform steps 24-11 through 24-12 only when installing cargo
soft-top enclosure.
24-11. Install cargo soft-top enclosure (32). (Refer to TM 9-2320-280-10.)
NOTE
Ensure all slack has been taken out of cargo soft-top enclosure,
and that cargo soft-top enclosure has been properly installed.
24-12. Using antenna (25) as template, locate, mark, and drill four 0.375-in. holes (33) and cut "X" (34) in
cargo soft-top enclosure (32).
24-13. Install antenna (25) on antenna mount assembly (23) and cargo soft-top enclosure (32) with
gasket (26), eight lockwashers (31), and four nuts (30), ensuring that ground strap (29) is inserted
through cut hole (34).
24-14. Install ground strap (29) on antenna mount assembly (23) with screw (28), three lockwashers (27),
and nut (18).
24-15. Tighten all nuts (18) and (30).
24
24
31
31
25
25
26
34
26
31
32
30
23
~
29
33
33
31
29
27
30
28
18
27
18.
NUT 9419143 QTY. 1
24.
CAPSCREW B1821BH038C150N QTY. 4
25.
ANTENNA A3017889-2 QTY. 1
26.
GASKET A3013655-1 QTY. 1
27.
LOCKWASHER MS45904-68 QTY. 3
28.
CAPSCREW B1821BH025C075N QTY. 1
29.
GROUND STRAP
BRAIDED WIRE AA59569F30T0375 QTY. A/R
TERMINAL LUG MS20659-141 QTY. 2
30. NUT 13218E0320-293 QTY. 4
31. LOCKWASHER MS45904-76 QTY. 8
Figure 5-96.
5-78
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |