 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|  TB 11-5820-890-12
d.
Follow the steps when using the troubleshooting table:
WARNING
The lithium battery used with your manpack radio is hazardous if misused or tampered with before, during,
or after discharge. Strictly observe the following precautions to prevent injury to personnel or damage to
equipment.
DO NOT heat, short circuit, incinerate, crush, puncture, disassemble, or otherwise mutilate battery.
DO NOT recharge or test batteries for capacity.
DO NOT store battery in equipment during periods of non-use.
TURN OFF equipment immediately if you feel battery case becoming very hot, hear battery venting (hissing
or burping), or smell irritating gas (sulphur dioxide). Remove battery only after it cools to the touch; then
return it to supply for disposal.
MALFUNCTION
POSSIBLE CAUSE
CORRECTIVE ACTION
Look here for your
If you find your problem
This will tell you how to possibly
problem.
under MALFUNCTION, this
correct your problem.
will give you the possible
cause.
No display
On/Off key not depressed
Press On/Off key
No display
Defective/dead battery
Change battery
Low battery indicator on
Low battery
Change battery
Low battery indicator on or
Battery contact defective or
Clean contacts or return unit to
no display
corroded contacts
next authorized level of
maintenance
ANCD will not transfer data
Fill connector damaged or
Clean fill contacts first, replace
corroded
unit if connector damaged
ANCD will not transfer data
Fill cable damaged or
Clean contacts first, replace
corroded
cable if suspected defective
ANCD displays error
Internal hardware/software
Follow full function ANCD
message
troubleshooting procedures.
4-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals