B-4. Tool and Test Equipment Require-
number of task-hours specified by the "work time"
ments (Sec. Ill)
figure represents the average time required to
restore an item (assembly, subassembly, compo-
a. Tool or Test Equipment Reference Code. T h e
nent, module, end item or system) to a serviceable
numbers in this column coincide with the numbers
condition under typical field operating conditions.
used in the tools and equipment column of the
This time includes preparation time, troubleshoot-
MAC. The numbers indicate the applicable tool or
ing time, and quality assurance/quality control
test equipment for the maintenance functions.
time in addition to the time required to perform the
b. Maintenance Category. The codes in this
s p e c i f i c tasks identified for the maintenance
column indicate the maintenance caterogy allo-
functions authorized in the maintenance alloca-
cated the tool or test equipment.
tion chart. Subcolumns of column 4 are as follows:
c. N o m e n c l a t u r e . This column lists the noun
n a m e and nomenclature of the tools and test
equipment required to perform the maintenance
d. National/NATO Stock Number. This column
l i s t s the National/NATO stock number of the
specific tool or test equipment.
e. Tool Number. This column lists the manufac-
turer's part number of the tool followed by the
e. Column 5, Tools and Equipment. Column 5
Federal Supply Code for manufacturers (5-digit) in
specifies by code, those common tool sets (not
individual tools) and special tools, test, and support
B-5. Remarks (Sec. IV)
e q u i p m e n t required to perform the designated
a Reference Code. This code refers to the
appropriate item in section II, column 6.
f. Column 6, Remarks. Column 6 contains an
b. Remarks. This column provides the required
a l p h a b e t i c code which leads to the remark in
explanatory information necessary to clarify items
section IV, Remarks, which is pertinent to the item
appearing in section II.
opposite the particular code.