Recoverability code - TM-11-5821-260-24P0004

TM 11-5820-26-24P

H-Support item is removed, replaced, used at the general support level.

D-Support items that are removed, replaced, used at depot, mobile depot, specialized repair activity only.

NOTE

Codes "I" and "F" will be considered the same by direct support units.

(b) The maintenance code entered in the fourth position indicates whether the item is to e repaired and identifies the

lowest maintenance level with the capability to perform complete repair (i.e., all authorized maintenance functions). This

position will contain one of the following maintenance codes:

Code

Application/Explanation

O-The lowest maintenance level capable of complete repair of the support item is the organizational level.

F-The lowest maintenance level capable of complete repair of the support item is the direct support level.

H-The lowest maintenance level capable of complete repair of the support item is the general support level.

D-The lowest maintenance level capable of complete repair of the support item is the depot level, performed by depot.

(3) Recoverability code. Recoverability codes are assigned to support items to indicate e disposition action on

unserviceable items. The recoverability code is entered in the fifth position of the uniform SMR Code Format as follows-

Recoverability

Code

Definition

Z-Nonrepairable item. When unserviceable, condemn and dispose at the level indicated in position 3.

D-Repairable item. When beyond lower level repair capability, return to depot. Condemnation and disposal not

authorized below depot level.

L-Repairable item. Repair, condemnation, and disposal not authorized below depot/Specialized Repair Activity level.

A-Item requires special handling or condemnation procedures because of specific reasons (i.e., precious metal content,

high dollar value, critical material or hazardous material). Refer to appropriate manual/directives for specific

instructions.

c. Federal Stock Number. Indicates the Federal stock number assigned to the item and will be used for requisitioning

purposes.

d. Part Number. Indicates the primary number used by the manufacturer (individual, any, firm, corporation, or

Government activity), which controls the design and characteristics of the item by means of its engineering drawings,

specifications standards, and inspection requirements, to identify an item or range of items.

NOTE

When a stock numbered item is requisitioned, the repair part received nay have

a different part number than the part being replaced.

e. Federal Supply Code for Manufacturer (FSC M). The FSCM is a 5-digit numeric code listed in SB 708-42 which is

used to identify the manufacturer, distributor, or Government agency, etc.

f. D escription. Indicates the Federal item name and, if required, a minimum description to identify the item. Items that

are included in kits and sets are listed below the name of the kit or set with the quantity of each item in the kit or set

indicated in the quantity incorporated in unit column. When the part to be used differs between serial numbers of the

same model. The effective serial numbers are shown as the last line of the description.

g. U nit of Measure (U/M). Indicates the standard of the basic quantity of the listed item as used in performing the

actual maintenance function. This measure is expressed by a two-character alphabetical abbreviation (e.g., ea, in, pr,

etc.). When the unit of measure differs from the unit of issue, the lowest unit of issue that will satisfy the required units of

measure will be requisitioned.

h. Quantity Incorporated in Unit. Indicates the quantity of the item used in the breakout shown on the illustration

figure, which is pre- pared for a functional group. A "V" appearing in this column in lieu of a quantity indicates that

specific quantity is applicable, (e.g., shims, spacers, etc).

4. Special Information

The following publications pertain to the AN/ARC-115 and its components:

1-2