|
| |
TM 11-5820-890-30-5
16-17. REPLACEMENT OF FILTER EMI-CCA.
Tools:
Cross tip screwdriver
Expendable supplies:
Solder
Alcohol
Cotton swabs
Soldering kit
ITEM
ACTION
REMARKS
REMOVAL
a. Eight screws (5) and
Iockwashers (6)
b. Screw (19) and
Iockwasher (18)
c. FILTER EMI-CCA wires
d. Two screws (25),
flat washers (24), and
Iockwashers (23)
e. FILTER EMI-CCA
INSTALLATION
f. FILTER EMI-CCA
g. Two screws (25),
flat washers (24), and
Iockwashers (23)
Use cross tip screwdriver. Remove and
inspect eight screws (5) and lockwash-
ers (6) securing access cover (1) to
connector case (12). If damaged,
obtain replacement. Lay access cover
to one side. See figure 16-3.
Use cross tip screwdriver. Remove and
inspect screw (19) and Iockwasher (18)
securing terminal lug (17) to FILTER EMl-
CCA. If damaged, obtain replacement.
Record location of wires soldered to
E1 and E2 of FILTER EMI-CCA.
Use soldering kit and soldering aid.
Desolder each wire.
Use cross tip screwdriver. Remove and
inspect two screws (25), flat washers
(24), and Iockwashers (23) securing
FILTER EMI-CCA to connector case (12).
If damaged, obtain replacement.
Remove and discard.
Obtain replacement FILTER EMI-CCA
and place in connector case (12).
Use cross tip screwdriver. Install and
hand tighten two screws (25), flat washers
(24), and Iockwashers (23) securing
FILTER EMI-CCA to connector case (12).
Inspect each screw and its
threaded screw insert (if
present) to determine if
any is defective. If a screw
is stripped, do not replace
its threaded screw insert,
If the holes are tapped,
there will be no threaded
screw insert.
16-21
|
